Announcement Announcement Module
Collapse
No announcement yet.
PO4 tab on the Param logger Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • PO4 tab on the Param logger

    I think it's a good idea to have that on there along with NO3.

    I just had an issue where no gfo, pellets or skimmer were in use. I obviously forgot to plug the skimmer back in after feeding filterers. Anyway when I discovered it I checked NO3 and for the hell of it checked phosphates too. They were .36!

    Now the skimmer had only been off for a week at most and I haven't run GFO or pellets in almost two months because I don't have an algae problem, which in my mind no algae = no excess nutrients.

    Anyhow now that I've got GFO running again it would be nice to have the PO4 recorded along with everything else so I can tell when the media is becoming saturated.

  • #2
    I use the 'log' tab for those measurements, but it does make finding them a bit of a pain in an amongst all the other entries.

    Comment


    • #3
      Originally posted by Ashlar View Post
      I use the 'log' tab for those measurements, but it does make finding them a bit of a pain in an amongst all the other entries.
      That's what I did too but would like to see them graphed out over the months. The peaks and valleys fascinate me. LOL

      Comment


      • #4
        we'll get on it.

        Comment

        Working...
        X